![]() ![]() I also tried it with a special uninstall program, but the data cannot be completely deleted there either. I uninstalled and reinstalled Zoiper, but it is probably the case that Zoiper is not completely uninstalled, but settings are already available again. Check the MUTE button if your phone has one. If I listen to music, it is output correctly via the headset. If you experience calls with one-way audio, or no audio at all, here are some possible causes and solutions. If I select a different output device, this also works, just not the audio output via the headset. Go to Settings -> Audio Make sure the input device and output device are selected properly. If you are using a laptop and expect to hear the sounds come out of the speakers, check to be sure that no audio headset (wired or bluetooth) is currently connected. The headset's microphone, on the other hand, works. First make sure your audio devices are configured properly in Zoiper. Unfortunately, no audio has been output via my headset since then, although this is defined in Zoiper as an output device and is also recognized (Sennheiser). When I was called, I set the volume above that which appears when you click on the loudspeaker symbol, which is in the footer between the letter symbol and the settings symbol. Any help would be appreciated.Unfortunately, I have had a problem with Zoiper since yesterday and cannot get it under control. It is also silent when I make an echo call (43). From online forums, it appears I'm not the only one having issues since the upgrade. Anytime I make or receive a call there is no audio, I cant hear the caller, and they cant hear me. The mfgs of the sound cards and USB sound device have made suggestions, but no luck. The sound cards and USB audio adapter also showed as working properly when they were installed. ![]() ![]() #Zoiper no audio drivers#465.89Īll devices and drivers show as working properly in Device Manager. #Zoiper no audio driver#Also tried going back to the older Realtek driver that had worked before, which is where I've left it. I've tried uninstalling, reinstalling, and/or updating drivers for Realtek, Nvidia and each sound device. There is still no sound through the Nvidia graphics card, monitors or speakers. If your initial setup have been working as expected for the time prior to the issues, and then a problem suddenly appeared, the most probable cause for it would be a network change, a change on the. Note that Zoiper is not controlled remotely. ![]() However there was still no sound when testing the USB audio in Windows' Sound Settings. Go to Settings again -> Audio Wizard and check if you are able to hear the test sound. #Zoiper no audio software#That showed promise when I tested the speaker config in their software - it produced sound through the speakers. My latest attempt was to use a USB Audio Adapter. There is no BIOS to disable the Realtek sound chip, but I completely removed the device drivers, etc., when I installed each sound card. So I tried sound cards from 2 different manufacturers. I've tested the receiver and speakers and they work. Prior to that my Realtek on-board sound chip worked well with my JVC receiver and surround speaker system. I have configured the PBX using the UCM6xxx Remote Extensions Conifguration Guide and can connect from a remote location to the PBX using Zoiper and GS Wave Light for iPhone, and can connect to the web interface for Grandstream Wave Web, log in, and dial numbers but there is no audio from the other end. various bug and crash fixes - fix for audio(music) routing issues after calls //referred by users as low volume for music or no audio// Get it at. After that upgrade, I've had no sound through my displays or speakers. My sound issue has been going on since 1/13/21 when I installed the 20H2 Win10 update. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |